![]() Also included is a environmentally sealed relay that has a mounting boss as well. Note: a higher current fuse may be required if fuel pressure is run excessively high. *FST WIRING HARNESS - FULLY POPULATED* This fully assembled universal wiring harness is designed to work for the following Radium Engineering fuel surge tanks: Single pump Walbro GSS342 255lph FST Single pump Walbro F90000262 Gas FST Single pump Walbro F90000267 E85 FST Single pump AEM 50-1000 Gas FST Single pump AEM 50-1200 E85 FST Single pump Aeromotive 11142 FST Single pump DeatschWerks FST Single pump Bosch 0 580 254 044 FST The harness includes a environmentally sealed mini fuse holder that has an integrated mounting boss. However, they can be used in any application using a 3/4"-16 O-ring port which is the same thread pitch used in -8AN fittings. *ALUMINUM 3/4-16 O-RING PORT FITTINGS* These adapter fittings are designed to be used in many Radium products including fuel rails, surge tanks, fuel pressure regulators, etc. * Determine if a pump needs to be included and select which Walbro version will be used. * Replacement FST Perimeter O-rings (x16) * Stainless Steel Pinch Clamp, Factory Crimped * Billet Aluminum Bulkhead Fitting with O-ring * Internal Bulkhead Wiring for Walbro (specify which pump) * Walbro 400 specific Laser Cut Mounting Bracket * Walbro 400 specific Billet Aluminum Bottom Cap The following parts will be reused: billet FST canister, billet FST top cap, three -6AN port fittings, -6AN bulkhead nut, 16 perimeter M5 bolts, 2 internal M5 bolts, external wiring harness, external mounting bracket and hardware This kit is only compatible when the original FST used one of the following pumps: Walbro GSS342 255lph, AEM 50-1000 Gas, AEM 50-1200 E85, Aeromotive 11142 or a Deatschwerks. *CONVERSION KIT FOR WALBRO F90000262 GAS AND F90000267 E85 PUMPS* This kit enables a Radium FST to be converted to use a single Walbro F90000262 Gas or Walbro F90000267 E85 fuel pump. This bracket is made from laser cut aluminum and powder coated black. It can be mounted on a floor and against a wall. *Angled Mount* - This mounting bracket is used for vehicles that may have a limited mounting height. This assumes the bracket is mounted to an electrically conductive material such as a steel frame. ![]() It is not only nickel plated to resist corrosion, it also allows for components to be grounded to the spare hole in the bracket. *Frame Mount* - Because this bracket has a 90deg formed bend and is cantilevered, it is constructed from steel for superior strength. *Floor and Wall Mount* - This bracket is laser cut from aluminum and powder coated black and can be mounted on the side or bottom of the surge tank. ![]() It should also be mounted away from common collision areas. Mounting locations near heat sources or moving parts such as suspension components should be avoided. The fuel surge tank can be mounted near the main fuel tank or in the engine bay. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |